ANALOG DIGITAL FIBER OPTIC TRAINER

ANALOG DIGITAL FIBER OPTIC TRAINER
This is a single board Fiber Optic Trainer Kit to study the characteristics of Fiber using Digital and Analog techniques. This kit also facilitates with digital and analog Modulation & Demodulation communication techniques.

Features:

·    660nm and 820nm Transmitter.

·    Two Nos. Of Photo Detector.

·    On-board Sine & Square wave generator.

·    On-board 4th Order Low Pass Filer. 5

·    On-board Fault Switch.

·    In-Built Power Supply.

 

Specifications:

·    Two Transmitter Fiber Optics LED having peak wavelength of emission 660nm & 950nm

·    Two Receiver Fiber Optic photo detector

·    On-board Analog & Digital Drivers.

·    On-board AC Amplifiers.

·    Analog Band Width 350 KHz

·    Digital Band Width 2.5 KHz·

·    4 order Butterworth 3.4KHz Low Pass Filter

·    On-board 1Hz. To 10 KHz sine wave (amplitude adjustable), square wave (NRZ-TTL8 Bit)

·    FO voice link using microphone & speaker

·    RS-232C PC to PC Serial Link using 9 pin D-Connector.

·    Four Switched Faults for transmitter & receiver

·    Fiber Optics Cable Connector type Standard SMA.

·    Duly polished fiber at both end for Numerical Aperture Measurement.

·    Step indexed multimode PMMA plastic cable.

·    Core Refractive Index 1.492.

·    Clad Refractive Index 1.406.

·    Numerical aperture Better than 0.5.

·    Acceptance Angle Better than 60

·    Outer Diameter 2.2mm.

·    Fiber Diameter 1000 microns.

·    Fiber Length 1m.

·    In-Built Power Supply +5V/1.5A, ±12V/250mA.

·    Interconnections 2 mm Banana Sockets

·    Attractive Plastic enclosures of Light weight with safety precautions.

·    User's Manual with set of Patch Chords.

·    230mm x 140mm
Weight 3 Kgs