Bending Device

Bending Device
Bending Device for Science Lab Equipment Laboratory Instruments Manufacturers, Engineering Lab Equipments Manufacturers

Technical Description of Bending Device
Using this accessory for the universal material teste a bending bar is investigated. This is mounted on two supports and loaded with a point force generated by the tester. By sliding the bearing it is possible to apply the force in different positions and change the support width. An I-section steel beam is used as the base. This is straightforwardly bolted to the lower cross-member on the. Using the apparatus, the relationship between load and elastic deformation can be demonstrated. The influence of the modulus of elasticity and planar moment of inertia is also demonstrated.

Specification of Bending Device

    Supplementary experiment on the universal material tester for the elastic deformation of bending bars subject to a point force
    Test bar made of cold drawn flat steel
    Cross-section 40x12mm, length 320mm
    Support width adjustable width
    Moveable bearing, semicircular seat
    I-section steel beam as bearing base
    Comprehensive experiment instructions, also as

Technical Data of Bending Device
    Bending bar
    Flat steel cold drawn
    Cross-section: 40x12mm
    Length: 320mm
    Support width, adjustable: 100...300mm